In this report we’re going to look at how to make your own dog mask. We’ll cover the basics and then go on to look at a number of the more advanced tips and tricks that you can use.
For those who have a dog that likes to bark, and particularly if your dog loves to play in the garden and other regions of the house, you need to get them some particular dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the set-up which will look a little scary at first, but it is actually quite simple. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not just cut a rectangular shape from the cardboard, so you’ll need to cut around the edge of the mask so that you get something that resembles a cone. The most important thing here is to be realistic with what kind of paper plate that you’re using.
Then you will have to wrap the cardboard around the edges of the paper plate, making certain that there is a good seal between the two pieces so http://esi.exapartners.com/?p=24155 that you can ensure that nothing will leak when you place the mask on. Make sure that the edges are cut so that the edges are not sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making sure that it runs smoothly and evenly across the whole mask. You will want to start with one side of the mask first, so that you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it’s best that you leave about one-fifth of an inch of paint on the edges so that it runs across the cardboard.
Don’t worry too much about the paint getting stuck to your mask. It’s easy to eliminate it later, and it’ll leave you with a wonderful finished mask to show off to everybody! It’s also a good idea to wipe away any excess paint after you’re done, so you don’t wind up with smudges or smears on your dog.
Then it’s time to glue the mask on your dog’s head. First you will need to make sure that you get a secure fit between the mask and your dog’s head. Once you’ve made sure that it’s secure, then you may begin to glue the mask on the dog’s face. Take the piece of cardboard that’s used for the foundation of the mask and fold it over. Make sure that it’s quite powerful and then use your hands to ensure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you have the mask snugged securely onto the surface of your dog. Do not make the folds too large or else it might look messy. As soon as you’ve completed this, you can then take out the mask and then attach the cardboard ears. And attach the other area of the mask onto the dog. Make certain the ears are flat and be certain it’s not too short or long as this can cause some issues with the mask slipping off the dog’s face.
If you are using a dog mask because your pet security, you will have to do some sanding to be certain it is safe on your dog. You can do it by sanding off any excess paper which might have been eliminated from your mask.